Switching solenoids On/OFF

Switching magnets with pressure-resistant core tube up to 350 bar.

The force-current characteristic has an increasing head and can be adapted to customer-specific requirements.

Specially designed for use in oil hydraulics, manual override and various electrical connector types (also MIL solutions) are optionally available. The mechanically and electrically robust design guarantees a long service life and reliable operation even under adverse environmental conditions. For devices of this series, we offer extensive advantages already from medium batch sizes, such as individual identification via serial number, with access to the test protocol.

Dimensions: 25 x 25 mm, 35 x 35 mm, 45 x 45 mm, 60 x 60 mm
The technical data can be taken from the attached table.

Data sheet

All advantages and variants at a glance:

1. VARIANTS

Device socket: DIN / AMP / German / free stranded wire
Voltage in volts: 12 / 24 / 230
Tappet with thread or clevis
Square design
Manual override
Sizes 25 / 35 / 45 / 60

2. Ex and NON- Ex Variants

This proportional solenoid is also available as Explosion-proof device available.

3. ADVANTAGES

high power density due to square housing design
pressure resistant from 100 bar to 350 bar
Compact size
Low hysteresis

4. ADVANTAGES

Hand emergency switch
durable robust design
Compact size

Technical details

General
Medium:	Mineral oil
Maximum operating pressure:	see table

Elektrische Daten
Operating voltage:	see table 1
Power consumption:	see table 1
Pull power:	see table 1
On-time:	S1
Electrical connection:	DIN A, B, C, AMP, DT, Desina etc.
Class of insulating material according to VDE 0580:	F
Insulation strength:	≥ 10M Ohm

Environmental conditions
Temperature
Medium:	-40° to +135°
Environment:	-40° to +135°
Protection type (DIN40050):	IP65, depending on plug type
Wear resistance of housing material:	Iron parts galvanized according to DIN 50979 Fe//Zn8//Cn//T0